Xetec Graphix AT Printer Interface
- Year
- 1987
- Type
- Interface
- Category
- Smart SIO-to-Centronics printer interface
- Manufacturer
- Xetec, Inc. (Salina, Kansas)
- Tags
- printer-interface, centronics, xetec, graphics, atascii, sio, listing
Overview
Most third-party printer interfaces passed characters straight through. Atari's graphics symbols and inverse-video characters then came out as gibberish on a standard printer, so programmers had to save listings to disk and run a special "lister" program. The Graphix AT from Xetec, Inc. of Salina, Kansas, better known for its Commodore interfaces, fixed that in hardware. It has its own microprocessor and a ROM holding the Atari character set in printer-graphics form. Type LIST "P:" from BASIC and you get a printout of the program as it appears on screen. Antic's January 1987 review found it faster than any lister program the reviewer had used.
Specifications
| Item | Value |
|---|---|
| Price (Antic, January 1987) | $69.95 |
| Connection | SIO cable to an interface box with a 36-contact Centronics plug |
| Power | From the printer: pin 18 must supply 5 V at 50 mA |
| Modes | Graphix (Atari characters printed as graphics) and Transparent (everything passed straight through) |
| Configuration | DIP switches |
| Fully supported printers | Epson, Gemini, Okidata, Prowriter 8510/8023, Banana GX-100, Blue Chip Legend, Epson 132-column; daisy-wheel printers without graphics |
How it works
In Graphix mode the interface sends ordinary letters and digits straight to the printer. When it meets an Atari special character, it switches the printer into dot-graphics mode and prints the matching bitmap from its ROM. The Atari's 6502 does no conversion, so the computer sends the listing at full speed. Special symbols are a small part of a typical listing, under 10% according to the reviewer. Transparent mode turns the conversion off for word processors, Print Shop and other software that expects a plain interface.
Limitations
Antic's reviewer noted a few trade-offs: - Graphix output is draft quality only. Letters in inverse video are drawn slightly differently, and inverse lowercase letters lose their descenders. - The ESC character never prints, because the interface uses ESC plus a second key for its own commands. Listings containing ESC still need a software lister. - On a 1200XL you have to cut a wire and solder a trace, because of how the interface takes power.
He still recommended it to "programmers and non-programmers alike". A June 1989 Antic I/O letter gave a fix for running The Newsroom with a Graphix interface on a Panasonic 1080i: choose the Epson MX-70 driver and set Xetec DIP switch 2 ON.
Using one today
Make sure your printer supplies +5 V on Centronics pin 18, which Antic's reviewer described as standard on printers of the day. The interface takes its power from there.
Credits
- Picture: The Xetec Graphix AT printer interface. — Photo from Gury's Atari 8-bit Forever portal (Graphix AT) (Unknown, used for identification)
- Antic Vol. 5 No. 9 (January 1987), Product Reviews: Graphix AT (Kevin Peck) — AtariMagazines.com (Kevin Savetz), 1987
- Antic Vol. 8 No. 2 (June 1989), I/O Board: Xetec DIP-Fix — AtariMagazines.com (Kevin Savetz), 1989
- comp.sys.atari.8bit FAQ (Michael Current), section 4.6 (Xetec Graphix AT supported printers) — Michael Current (comp.sys.atari.8bit FAQ)
