Atari XM301 Modem

Year
1985
Type
Peripheral
Category
Modem (300 baud direct-connect, SIO-powered)
Manufacturer
Atari Corp. (made in Taiwan)
Small grey Atari XM301 modem

Overview

The XM301 was Atari Corp.'s budget modem for the XE generation. Announced at the January 1985 CES at "under $50" and shipped in December 1985, it is a small grey box with a permanently attached SIO cable and a modular phone jack. It has no power adapter at all: it draws about 60 mA at 5 V from pin 10 of the SIO port. Despite its size it offers auto-dial and auto-answer with tone or pulse dialling, and it is software-compatible with the older 1030, so programs written for the 1030 generally work with it. Jose Valdes was its key engineer.

Antic's shopping guides called it "this worthy successor to the Atari 1030" (December 1986, $49.95) and noted that the package included "a fine 49-page manual" and the XE Term communications program by Russ Wetmore, which supports XMODEM file transfers.

Specifications

Item Detail
Speed / standard 300 baud, Bell 103
Dialling Tone and pulse; auto-dial and auto-answer
Electronics Intel 8048 microcontroller; National Semiconductor MM74HC943 300-baud modem chip
Frequencies Originate: transmit 1270/1070 Hz, receive 2225/2025 Hz; answer reversed
Sensitivity −13 to −46 dBm; carrier detect on at −44 dBm, off at −45 dBm
Audio No speaker; phone audio can be routed to the TV/monitor
Connection Built-in SIO cable (must be last on the chain); RJ11 phone jack
Power 5 V, about 60 mA from SIO pin 10
Software XE Term disk (DX5076)
Manual Atari XM301 Modem Owner's Manual C026119 (1985)

History and use

Antic's May 1988 "Choosing Your Modem" column noted that new or used XM301s, older 1030s and "even a few ancient 835s" were still easy to find for $50 or less and saved buying an RS-232 interface — though at 300 baud they were slow next to the new 1200-baud SX212. Software support was broad: Keith Ledbetter's Express! terminal had a dedicated 1030/XM301 version, BBS Express! ran a bulletin board on it, many AMODEM variants were patched for the 1030/835/XM301 family, and Antic confirmed that the PRO*TERM type-in terminal worked with it unmodified.

Using it today / Known issues & tips

  • Not for the 1200XL without modification: the 1200XL does not supply power on SIO pin 10, and the XM301 manual itself says it cannot be used with a 1200XL unless the computer has been modified.
  • Last on the chain. The fixed cable has no pass-through port.
  • Internal wiring. Antic's 1988 SX212 review mentioned concern among XM301 owners about bare wire tips loose inside the case, though it was unclear whether this had ever caused damage — worth a look if you open one up.
  • Hayes it isn't. The XM301 uses Atari's own 1030-style command protocol, not the Hayes AT command set; software must support it specifically.

Credits