Atari 835 Direct-Connect Modem

Year
1983
Type
Peripheral
Category
Modem (300 baud direct-connect, SIO)
Manufacturer
Atari, Inc. (made by Racal-Vadic)
Atari 835 direct-connect modem

Overview

The 835 was the modem that freed Atari owners from the 850 interface. It plugs into the telephone line with a standard modular (RJ11) jack — no handset cradle — and into the computer through the SIO bus, so a complete telecommunications setup needed only the modem, a cable and software. It runs at 300 baud using the Bell 103 standard. Inside, an Intel 8048-family microcontroller drives a Texas Instruments TMS99532 FSK modem chip; the unit was made in the USA for Atari by Racal-Vadic.

The 835 was sold only as part of The Communicator II kit (CX488): modem, power adapter, SIO and telephone cables, a getting-started guide, and the TeleLink II terminal cartridge. TeleLink II added 1 KiB of non-volatile memory in the cartridge itself for storing the names, phone numbers and sign-on codes of two online services, and it supports both the 835 and the older 830.

Specifications

Item Detail
Type Direct-connect FSK modem
Speed / standard 300 baud, Bell 103; originate and answer frequency bands
Dialling Pulse only
Audio No speaker; line audio can be routed to the TV speaker under software control
Electronics 8048-family microcontroller at 4.032 MHz with 1 KiB internal ROM; TI TMS99532 modem chip
Connection SIO; telephone line jack and telephone jack (RJ11C)
Power 20–22 V AC from Atari C060479 adapter (CA060535); 18 W
Service manual Atari 835 Direct Connect Modem Field Service Manual FD100268

History

Atari announced The Communicator II and the new 835 at the June 1982 Summer CES, then promised the modem separately for spring 1983 — a plan dropped by the June 1983 show, when the kit was confirmed for July. It finally shipped in the autumn of 1983 at $279.95, sold in the U.S. and Canada. By then Atari had already introduced the 1030 (June 1983), which could be bought on its own and loaded its software from ROM, and the 835 remained a short-lived product.

How it talks to the computer

The 835 does not use normal SIO command frames. Everything happens at 300 baud: commands are single bytes sent while the SIO command line is held active, covering functions such as originate/answer mode, pulse dialling, on/off hook, break, loopback test, enabling the phone audio, and suspending or resuming the data stream. Because it ignores the motor line, it is always listening, and other devices on the bus simply reject its bytes as bad frames. Once data transfer is resumed, the modem relays characters between the phone line and SIO, re-timing each bit; it has one byte of buffering and no flow control.

Using it today / Known issues & tips

  • TeleLink II or compatible software is required — the 835's protocol is unique, so terminal programs must explicitly support it.
  • Emulation. Altirra includes both standard and full hardware emulation of the 835.

Credits