CSS XF551 Enhancer
- Year
- 1989
- Type
- Upgrade
- Category
- Disk drive modification (flippy formatting)
- Manufacturer
- Computer Software Services (CSS), Rochester, New York
Overview
Owners of Atari's single-headed 810 and 1050 drives used to cut a second write-enable notch in a disk, turn it over and format the back. Each side became a separate disk with its own directory. These "flippies" were everywhere. Atari's XF551 has two heads and a true double-sided mode, and it refuses to format the back side of a flippy, even when the disk is notched. It can read and write a flippy's second side once another drive has formatted it, but it can't create one.
The XF551 Enhancer from Computer Software Services (CSS) removes that restriction. It's a small sealed black module with a toggle switch and seven wires that solder into the drive. Antic reviewed it in May 1989 at $29.95.
What it actually fixes
CSS's advertising said the XF551 wrote side two "BACKWARDS" and that this broke compatibility with other drives. Antic's reviewer, Matthew Ratcliff, said that wasn't quite right. A disk formatted double-sided, double-density (360K) by DOS XE, SpartaDOS or MYDOS is one logical disk with one directory covering both sides. It does run the second side in the opposite direction, but that side was never meant to be read as a flippy, because it has no directory of its own. The real problem was Atari's format lock-out. Atari had added it to stop people formatting the back of an already double-sided disk by habit.
With the Enhancer, the drive can make either kind of disk at the flip of a switch:
| Switch position | Result |
|---|---|
| Toward the black wire | The flip side of any disk can be formatted, with or without a write-enable notch |
| Other way (normal) | Atari's protection is back on, and the flip side of a double-sided disk can't be formatted by accident |
There are no markings on the switch. The reviewer labelled the back of his drive "FLIPPY" and "NORMAL" and mounted the switch between the two words.
Installation
The kit has the module, the toggle switch, double-sided tape for fixing the module to the metal bracket inside the back of the drive, a 16-step instruction sheet and a hand-drawn schematic. You connect seven wires to points on the mechanism and the circuit board, and cut and resolder one jumper. Nothing needs desoldering and no traces are cut. Antic estimated half an hour for an experienced solderer and about an hour for a careful beginner, and said the written steps were clear enough to skip the schematic. Like any modification, it voided the XF551's 90-day Atari warranty.
Tips
- Notch your flippies anyway. Ratcliff advised keeping the Enhancer switched off except when formatting a flippy. A notched flippy can be written on the XF551 without the switch on, and the notch reminds you which disks are flippies and which are true double-sided disks.
- Why you'd still want flippies: in 1989 there were far more 810 and 1050 drives than XF551s. Flippies let you swap data with friends' drives and with Rana, Indus and other single-sided drives.
- Drive mechanism matters. XF551s fitted with the rarer Chinon mechanism use the index hole and can't use a flippy's back side without a second index hole. See XF551.
- Software alternatives. Several later firmware replacements for the drive change its behaviour more thoroughly. See XF551 ROM patches.
Credits
- Antic Vol. 8 No. 1 (May 1989), New 8-Bit Power Tools: XF551 Enhancer (Matthew Ratcliff) — AtariMagazines.com (Kevin Savetz), 1989
