Atari XF551 Disk Drive

Year
1987
Type
Storage
Category
5.25-inch floppy disk drive (double-sided, double density)
Manufacturer
Atari Corp. (made in Japan; Mitsumi and Chinon mechanisms)
Grey XE-styled Atari XF551 disk drive with turn latch

Overview

The XF551 finally gave Atari's own product line what third-party drives had offered for years: true double density and double-sided disks. Introduced at the June 1987 CES and shipping around the end of 1987, it reads and writes the 810's 90K single density and the 1050's 130K enhanced density, and adds 180K double density (256-byte sectors, compatible with Percom-standard third-party drives) and — thanks to a second head — 360K double-sided double density. In 360K mode it can also talk to the computer at roughly double the normal SIO rate. Its key engineer was Jose Valdes.

Antic's June 1988 review found it "eerily silent" next to the "coffee grinder" 810 and "bear growl" 1050, noted its $199.95 list price matched the 1050 it replaced, and recommended it "without hesitation", while observing that with the DOSes then available it was only modestly faster than a 1050.

Specifications

Mode Encoding Sides Tracks Sectors/track Bytes/sector Capacity
Single FM 1 40 18 128 92,160
Dual ("enhanced") MFM 1 40 26 128 133,120
Double MFM 1 40 18 256 184,320
Double-sided double MFM 2 80 18 256 368,640
Item Detail
Controller Intel 8040 or 8050 microcontroller at 8.33 MHz with 4 KiB firmware; Western Digital WD1772 FDC (WD1770 in late units). (Early reports, including Antic's review, wrongly said 6507.)
SIO speed Normal 19,040 bit/s NTSC (18,688 PAL); high speed about 38,900 bit/s NTSC (38,553 PAL) — 360K mode only
Rotation 300 RPM
Connection 2 SIO ports; drive number via two rear DIP switches; power switch at the rear and no power light
Power 9 V AC (Atari CA017964), the same adapter as the 810/1050
Bundled DOS DOS 2.5 (1987–88), DOS XE (from January 1989)

Versions

Most XF551s use a Mitsumi mechanism (green rectangular busy light under a straight latch). It ignores the index hole when reading and writing, so it can use the back of a "flippy" disk in single-sided modes. Rare late Chinon units (round red light beside an angled latch) eject the disk when the latch opens and use the index hole, so they cannot read or write a flippy's back side without a second index hole. Both types use the index hole when formatting, which is why Antic's reviewer found that side B of his flippy disks would not format.

Using it today / Known issues & tips

  • DOS support for high speed. The XF551's fast mode works with DOS XE, SpartaDOS X, XDOS, MyPicoDos, Micro-SpartaDOS, SuperDOS, Turbo-DOS and BW-DOS (and a patched SpartaDOS 3.2d).
  • Fragile disks. The XF551 is more likely than other Atari drives to damage poor-quality old disks, apparently because its heads press slightly harder.
  • Double-sided layout. Side 2 runs from the inside track outwards; double-sided disks from drives using other conventions are not compatible.
  • Handling. Antic advised fitting the cardboard head protector before moving the drive and never removing a disk while the busy light is on.
  • 3.5-inch conversions. The mechanism uses standard connectors, which led to Innovative Concepts' XF35 kit (1988), CSS's XF single and dual drive upgrades and XF Update ROM, Klaus Peters' XF Speedy and Stefan Dorndorf's Hyper-XF firmware.
  • Emulation. Altirra offers full XF551 firmware emulation, including detection of several XF551 ROM versions.

Compatibility

Works with all 8-bit Atari computers. The XF521 (a 5.25" XE-styled 1050 replacement, 1985) and XF351 (3.5" drive, 1986–87) were previewed but never shipped, leaving the XF551 as Atari's final 8-bit drive.

Credits