UGV-II Ultimate Gated Video Board
- Type
- DIY project
- Category
- Video upgrade
- Manufacturer
- Michael St. Pierre (MyTek / AtariBits), open design
Overview
On a CRT television, the edges of the picture were hidden behind the tube's bezel. This overscan area was never meant to be seen, and some Atari games and demos use it to do untidy work out of sight, such as racing the beam and rewriting graphics mid-frame. Modern monitors and HDTVs show every line the Atari outputs, so that clutter becomes visible.
Michael St. Pierre's (MyTek) UGV-II ("Ultimate Gated Video", the second version) fixes this in hardware and replaces the Atari's video output stage at the same time. It began as a stand-alone VGATE board and grew into a full video board. The same circuit is used in his 576NUC+ motherboard.
How it works
- VGATE overscan blanking. A PIC12F1572 clocked from GTIA's oscillator input (pin 28), multiplied by four with its internal PLL, runs fast enough to switch the luma and chroma off at exactly the right moments each line. Luma is gated by a 74F08 AND gate and chroma by a 2N7000 MOSFET. Grounding pin 7 of header J1 turns VGATE off. If you've removed the RF modulator, the old channel switch makes a handy on/off switch.
- New output stage. GTIA's digital luma lines feed a low-impedance resistor DAC driven by the 74F08, which has much more drive than the CD4050 in Atari's own circuit and so picks up less noise. That goes into a FMS6400 dual Y/C video driver, which DC-restores and filters luma and chroma into 75 Ω S-Video outputs and sums them for a separate composite output.
- No processing. The UGV-II passes the GTIA's signal through unchanged, including any quirks of your particular chip. St. Pierre contrasts this with Bryan's UAV board, which pre-processes the signal to correct some GTIA flaws but has no VGATE. He judges the picture-quality difference to be small.
Building and installing
- Parts: a 2-layer, 52.7 × 28.9 mm board that must be ordered 0.8 mm thick (from JLCPCB, for example), mostly through-hole parts, and one SMD chip, the FMS6400. The BOM (dated May 2025) puts the parts at under $20. The FMS6400 has been out of production for years, but St. Pierre has had no fakes from eBay or AliExpress sellers and suggests buying a spare or two. An all-SMD "UGV-II SM Edition" by Overange is shared on PCBWay.
- Firmware: flash the PIC12F1572 out of circuit with the VGATE firmware, then plug it into its socket.
- 600XL, 800XL, 1200XL: the board piggy-backs on the socketed GTIA (CO14805 NTSC or CO14889 PAL), so installation is virtually solder-free apart from feeding the outputs to the 5-pin A/V socket. An optional small board adds a Mini-DIN S-Video socket using off-the-shelf jumper wires.
- XE machines: GTIA is soldered in, so you must desolder it and fit a 40-pin socket, preferably a machined-pin one.
- 400/800: there is so little room under the RF shielding that the UGV-II has to be soldered in place of GTIA's socket, with GTIA plugged into the UGV. St. Pierre suggests a UAV instead for these machines.
- Disconnect the stock video from the A/V jack and route the UGV-II outputs there instead. The Brewing Academy's UAV installation manual shows how, and the same method applies.
Compatibility and tips
- It needs a real GTIA. It doesn't work with the virtual GTIA of Sophia 2 and 3 boards (you'd lose colour), although earlier Sophia versions are fine.
- In a 1200XL, St. Pierre recommends also fitting his static-RAM 1200XL-1mb upgrade, because the 1200XL's poor grounding lets DRAM refresh noise show up as faint vertical lines.
- For the most consistent output, the DAC resistors can be upgraded to 1% tolerance, although the specified parts work well.
See also video output and the monitor port and CTIA/GTIA.
Credits
- Picture: UGV-II, which piggy-backs on the GTIA chip. The headers carry composite, chroma and luma out. — Image: Michael St. Pierre (MyTek), AtariBits (CC BY-SA 4.0 (per AtariBits site notice))
- AtariBits — UGV-II Ultimate Gated Video Board — Image: Michael St. Pierre (MyTek), AtariBits (CC BY-SA 4.0 (per AtariBits site notice))
- AtariBits — Memory Expansion (1200XL-1mb SRAM upgrade) — Michael St. Pierre (MyTek), AtariBits (CC BY-SA 4.0 (per AtariBits site notice))
