SupraDrive and Supra Hard Disk Interface
- Year
- 1986
- Type
- Storage
- Category
- Hard disk system (parallel bus)
- Manufacturer
- Supra Corporation (Albany, Oregon); later K-Products
Overview
Supra Corporation's SupraDrive brought plug-in hard-disk storage to Atari XL and XE owners in 1986. Antic's Shoppers Guides called it "the first hard disk made for Atari 8-bit computers" and noted that it already ran "many Atari bulletin boards". Antic used one itself. Its 10 MB SupraDrive held "every 8-bit program ever published in the magazine" with more than seven megabytes to spare. The system was a paperback-sized interface box on the parallel bus connected to a shoebox-sized drive. Supra's 1986-1992 interface was later continued by K-Products (1992-2002) as the K-Products Interface (KPI).
Specifications
| Item | Value |
|---|---|
| Released | 1986 |
| Capacity | 10 MB at launch; 20 MB by 1988 |
| Drive | 10 MB: Xebec 4000 / Xebec Owl (5.25" SASI); 20 MB: reportedly a Miniscribe 8425S 3.5" SCSI (unconfirmed) |
| Interface | PBI box with its own pass-through PBI port; XE needs the Supra XE-XL Buss adapter ($16), which also passes a cartridge through |
| Cables | 50-conductor ribbon and 4-conductor power, each about 30 inches |
| Drive unit | Grey metal case, about 8.5 lb |
| Printer port | 40-pin PCB edge on the interface, with printer software utilities |
| Second drive | Supported if it has the same heads and cylinders as the first |
| Software | MYDOS 4.0 plus nine utilities (format/verify, park, write-protect, printer line feeds) |
| Price | $799 (10 MB, 1986); $699 (20 MB, 1988) |
How it works
The hard disk is split into two logical drives. D1: is the "fake floppy". It has a floppy's capacity in single or double density and works with any DOS, so the system normally boots from it. D3: is the rest of the disk, which only MYDOS (supplied) or SpartaDOS can fully address. A real floppy drive is set as D2: for copying files on and off. With a second hard disk, its fake floppy becomes D2: and its large partition D4:. Holding HELP at power-on boots from the floppy instead of the hard disk.
Antic's reviewer organised the magazine's archive into MYDOS subdirectories by issue, so a program loaded with commands like LOAD "D3:OCT86:CASTLE.BAS". Formatting and bad-sector checking took 10-20 minutes.
Known issues and tips
- Unmodified computers only. The review warned that OS replacement chips such as RAMrod and Omnimon "will severely damage the SupraDrive".
- Drive-1-only software. Programs that insist on drive 1, or don't get along with the hard disk, mean powering the system down, unplugging the interface and making a floppy D1: again. With two floppies it's simpler: turn off floppy 1 while the hard disk is in use.
- Park the heads with the supplied utility before moving the drive even a few inches. The drive unparks itself on the next boot.
- Controller choice. Like many Atari hard-disk interfaces, the Supra works only with controllers that support 256-byte sectors.
Context
In October 1988 Antic's review of ICD's FA-ST drive pointed out that Supra's 20 MB drive cost the same $699 but, unlike the FA-ST, didn't need ICD's Multi I/O board. That was a real advantage for owners who only wanted mass storage.
Credits
- Picture: The 10 MB SupraDrive for Atari 8-bit computers. — Photo from Gury's Atari 8-bit Forever portal (SupraDrive 10 Meg Hard Drive) (Unknown, used for identification)
- Antic Vol. 5 No. 6 (October 1986), SupraDrive for 8-bit Ataris (Charles Jackson) — AtariMagazines.com (Kevin Savetz), 1986
- Antic Vol. 5 No. 8 (December 1986) and Vol. 6 No. 9 (January 1988), Shoppers Guides — AtariMagazines.com (Kevin Savetz), 1986
- Antic Vol. 7 No. 6 (October 1988), FA-ST Hard Disk review (comparison note) — AtariMagazines.com (Kevin Savetz), 1988
- comp.sys.atari.8bit FAQ (Michael Current), sections 3.3.3 and 4.6 — Michael Current (comp.sys.atari.8bit FAQ)
