R-Verter / SupraVerter (SIO-to-RS-232 Modem Adapter)
- Year
- 1984
- Type
- Interface
- Category
- SIO-to-RS-232 modem adapter cable
- Manufacturer
- Advanced Interface Devices (A.I.D.); later Supra Corporation
Overview
An Atari 850 or P:R: Connection was the "proper" way to attach an RS-232 modem, but many owners only needed one serial device. The R-Verter Serial Bus Modem Adapter from Advanced Interface Devices (A.I.D.), introduced in 1984, is just a cable with a little circuitry: an Atari SIO plug at one end and a DB-25 male connector for a standard modem at the other. It came with several R: device handlers, so terminal software written for the 850 could use it. Supra later sold it as the SupraVerter and bundled it with the SupraModem 2400. Antic's January 1988 Shoppers Guide described it as converting "the 8-bit Atari's SIO port to an RS-232 port".
Specifications
| Item | Value |
|---|---|
| Connection | Atari SIO to DB-25P (modem side) |
| Electronics | Level shifting only, no UART |
| Enable | SIO motor-control line |
| Status lines | Carrier Detect to SIO Proceed, Data Set Ready to SIO Interrupt (inverted) |
| Software | Several R: handlers on disk |
| Limitation | Only one motor-line device on the SIO bus at a time |
How it works
The R-Verter doesn't use the normal SIO command protocol. When software turns the cassette motor-control line on, the adapter connects the modem's transmit and receive lines to the SIO data lines for full-duplex use and enables DTR sensing. When the motor line is off, the adapter disconnects. Because there's no UART, POKEY generates the serial bit timing, and the R: handler software takes care of parity and stop bits. The modem's Carrier Detect and Data Set Ready signals come back on the SIO Proceed and Interrupt lines, so software can see when a connection is made.
Similar adapters include the Digital Devices U-Call and the British Datatari interface for Prestel-style 1200/75 Viewdata. The motor-line trick means you can't use two such devices, or an R-Verter and another motor-controlled device, on the same SIO chain at once.
Using one today
- Load the R-Verter R: handler first, then any 850-style terminal program.
- Keep a program recorder off the chain while the R-Verter is in use, since both depend on the motor line.
- The R-Verter is still useful for connecting a Hayes-command serial "Wi-Fi modem" directly to an Atari. Several modern Internet-modem projects advertise R-Verter-compatible software for exactly this.
Credits
- Picture: The A.I.D. R-Verter serial bus modem adapter, with its manual and handler disk. — Photo from Gury's Atari 8-bit Forever portal (R-Verter) (Unknown, used for identification)
- comp.sys.atari.8bit FAQ (Michael Current), sections 5.1.3 (R-Verter, U-CALL, Datatari) and 5.1.5 (SIO2WiFi R-Verter compatibility) — Michael Current (comp.sys.atari.8bit FAQ)
- Altirra Hardware Reference Manual, section 9.16 R-Verter — Avery Lee (Altirra)
- Antic Vol. 6 No. 9 (January 1988), Sixth Annual Antic Shoppers Guide: Supra 300/1200/2400 (R-Verter cables) — AtariMagazines.com (Kevin Savetz), 1988
