1200XL Memory Upgrades (RAMBO to 1 MB)

Year
1986
Type
DIY project
Category
Memory upgrade family
Manufacturer
Various (ICD, Newell, Magna, Atarimax; homebrew designs by Bob Woolley and Michael St. Pierre)
Annotated photo of an Atari 1200XL motherboard: labels mark the SRAM board piggy-backed on the SALLY CPU, PIA and other chips, the inductor L11 to remove, and red crosses over the original DRAM chips and parts to take out

Why the 1200XL is a special case

The 1200XL (1983) was the first XL machine and the first with 64K RAM and the PORTB memory-control register. It differs from the later 800XL and 130XE in ways that matter for memory upgrades:

  • PORTB bits did other jobs. In the 1200XL, Atari wired port B into the memory banking and also used it to drive the machine's LEDs. On the 800XL five of those bits were left unused, and the 130XE then gave four of them the standard extended-RAM meanings. Kits designed around the 800XL therefore need extra jumpers on a 1200XL.
  • No built-in BASIC. Unlike every other XL/XE, the 1200XL doesn't enable a BASIC ROM at $A000–$BFFF. Upgrades that reuse PORTB bit 1 (the BASIC switch) for bank selection therefore cost a 1200XL owner nothing.
  • Space and keyboard. Hackers liked the 1200XL for the room inside its case and its keyboard, which made it a favourite for internal projects such as Woolley's PBI and SmartIDE work.

The options

Upgrade RAM Notes
ICD RAMBO XL (1986) 256K for the 800XL or 1200XL. A contemporary review called installation "reasonably straightforward", with significantly more jumpers on a 1200XL. Clones include the Atarimax 256K and MyTek's RAMBO XL-II. On a 1200XL these need the 64K DRAMs replaced with 256K chips
Newell 256KXL / 256KXLE, Newell 1 Meg XL / Meg XL 256K to 4 MB for the 800XL or 1200XL. See Newell 256KXL
Magna Systems Ramcharger 256K (1987) 256K for the 800XL or 1200XL, factory-installed. ANTIC sees main memory only. See Magna RAMcharger
Bob Woolley's 1 Meg 1200XL Upgrade (SLCC Newsletter, April 1992) 1 MB a homebrew project from the San Leandro Computer Club. Bank selection uses PORTB bits 1, 2, 3, 5, 6 and 7, with true ANTIC banking. It gives up the BASIC bit, which the 1200XL doesn't use anyway
mega-mem 1024KB (Reichl and Fischer, 2009) up to 1 MB eight switchable modes for the 800XL, 800XE/65XE, 130XE and 1200XL. See Mega-Hz
MyTek 1200XL-1mb 1088K an all-SRAM board described below
Ultimate 1MB 1 MB the modern all-in-one option for 64K XL/XE machines

MyTek's 1200XL-1mb (solder-less SRAM)

Michael St. Pierre's 1200XL-1mb is a plug-and-play static-RAM upgrade to 1088K total. It is designed to be completely reversible:

  • The board piggy-backs four existing chips, the MMU, decoder, CPU and PIA, to pick up every signal it needs. Pull those four chips, plug the board into their empty sockets, and put the chips into the board's own sockets.
  • Then remove all the chips of the original DRAM circuit. The photo above marks them with red crosses.
  • The only other change is an RF choke (inductor L11) used only by the RF sound section. Bend it over if it fouls the board, or cut it out if you don't use RF output.
  • There is no separate BOM. Parts come from the schematic (v1.2), which specifies 0.1 µF capacitors with 0.2-inch lead spacing and standard 3 kΩ ¼ W resistors. The board must be made 1 mm thick, 68.1 × 102.4 mm.

A welcome side effect is cleaner video. St. Pierre explains that the 1200XL's poor grounding lets DRAM refresh noise appear as widely spaced vertical lines on screen. Replacing the DRAM with SRAM removes the source, and he recommends this upgrade alongside his UGV video board.

Tips

  • Decide which banking scheme your software needs first. RAMBO-style upgrades suit RAM disks and most 130XE software. True ANTIC banking matters for programs that show one bank while working in another. See DIY XL/XE memory expansion.
  • Lee Brilliant noted in 1988 that freshly upgraded DRAM machines may need a wait of up to 20 seconds between power-off and power-on to clear memory, or POKE 580,1 and RESET for a cold start.
  • Many 1200XL chips are socketed, which makes piggy-back and plug-in upgrades much easier than on the XE machines.

Credits