Ultimate 1MB (U1MB)
- Type
- Modern device
- Category
- Internal multifunction upgrade: memory, OS/BASIC flash, SpartaDOS X, PBI BIOS
- Manufacturer
- Sebastian Bartkowicz (Candle'O'Sin); sold by Lotharek and others
- Tags
- modern, memory-upgrade, 1mb, flash, spartados-x, pbi, cpld, candle, u1mb, xl-xe
Overview
The Ultimate 1MB, usually called U1MB, is a widely used modern XL/XE upgrade. Designed by Sebastian Bartkowicz (Candle'O'Sin), it's a small board with a CPLD that takes over the sockets of the computer's MMU and OS ROM. That gives it control of the memory map in ways an external cartridge or PBI device can't match. In one board it provides up to 1 MB of extended RAM in several compatibility modes, a 512 KB flash ROM that replaces all the system's ROMs with selectable OS, BASIC and game images, built-in SpartaDOS X, and PBI device emulation, which its BIOS uses for features like high-speed SIO and close integration with the SIDE cartridges. Jonathan Halliday's replacement firmware (BIOS and SIDE loader) has expanded it further over the years.
Specifications
| Item | Value |
|---|---|
| Computers | Any 64 KB XL/XE (installed internally) |
| Logic | CPLD; revision 2 adds PBI device emulation (rev. 1 can be reprogrammed with an external programmer) |
| Extended RAM modes | Disabled; 320 KB "Rambo" (Atari Magazin); 576 KB "Compy-Shop" with true ANTIC banking; 1,088 KB "Rambo" |
| Flash ROM | 4 Mbit (512 KB): BIOS, four OS slots, BASIC slots, game ROM slots, PBI ROM, SpartaDOS X |
| Flash chips | Early units Amic A29040; later e.g. SST39SF040 (different sector sizes) |
| Configuration | Setup menu in the BIOS; flash writable from the Atari when enabled |
| Integration | SIDE/SIDE2/SIDE3 hard-disk and loader support, SIO2BT and PCLink support in firmware |
How it works
At power-on the U1MB maps its BIOS from flash in place of the OS ROM. The BIOS sets up the hardware according to your saved settings, such as memory mode, OS slot, BASIC on or off, and SpartaDOS X enabled. It then hands control to the chosen OS image, and it regains control on every reset. Because the U1MB holds all the system ROMs in one flash chip, putting that chip into programming mode makes the OS image vanish too. Interrupting a flash update with a reset can leave the computer unable to boot until it's power-cycled.
The memory modes cover the major banking standards, so 130XE software, Rambo-type RAM disks and Compy-Shop software with separate ANTIC access all have a matching mode. The U1MB's extended memory is separate from the motherboard RAM, which can change how some PBI devices behave. VBXE is a noted case.
Using it today
- Installation means removing the MMU and OS ROM (socketing them if they're soldered) and fitting the board. It's a common job for vendors and experienced hobbyists.
- Firmware updates are applied from the Atari itself. Jonathan Halliday's firmware adds a richer setup menu, PBI high-speed SIO, SIDE loader integration and plugins for SIDE3.
- Emulation. Altirra emulates the U1MB, including saving its state, so you can learn the BIOS menu before opening your machine.
- Companions. The U1MB pairs naturally with a SIDE2, SIDE3 or AVGCart for mass storage, and with SpartaDOS X from its own flash.
Credits
- Picture: The Ultimate 1MB board with its MMU and OS-socket cables. — Product photo from Lotharek's Lair (maker/vendor) (© Lotharek, used for identification)
- Altirra Hardware Reference Manual, section 12.3 Ultimate1MB (and 11.2 note on extended memory and VBXE) — Avery Lee (Altirra)
- comp.sys.atari.8bit FAQ (Michael Current), sections 6.12 (Ultimate 1MB memory modes), 3.3.5 (SIDE3 plugins), 5.4.2 (SIO2BT support) — Michael Current (comp.sys.atari.8bit FAQ)
- Altirra emulator release notes (Ultimate1MB in save states) — Screenshot from Avery Lee's Altirra page, virtualdub.org
