Atari 815 Dual Disk Drive

Year
1980
Type
Storage
Category
Dual 5.25-inch floppy disk drive (double density) — unreleased
Manufacturer
Atari, Inc.
Atari 815 dual disk drive with two stacked drive mechanisms

Overview

The 815 was Atari's first attempt at a high-capacity disk system: a single unit containing two disk mechanisms, each storing 180 KiB in double density — twice an 810. Introduced at the June 1980 Summer CES at $1,499.95 for autumn delivery, it was still being promised in May 1981 (with its own DOS II version, 2.0D) and appeared on an August 1981 company price list, but by October 1981 it had been dropped. It never went on general sale; reports put production at about 50–60 hand-assembled units. Either way, working 815s are extremely rare.

Its lasting legacy is a convention: the 815 treated sectors 1–3 as 128-byte sectors even on a 256-byte-sector disk, so that the Atari OS boot process would still work. Every later double-density Atari drive adopted the same rule.

Specifications

Item Detail
Drives Two single-sided mechanisms (top = drive 1, bottom = drive 2); Tandon in most samples, MPI in some
Format Double density (MFM) only: 40 tracks × 18 sectors × 256 bytes = 720 sectors, 184,320 bytes (180 KiB) per disk; sectors 1–3 handled as 128 bytes
Controller 6507 at 2 MHz, three 6532 RIOTs (384 bytes of RAM), MC6852 Synchronous Serial Data Adapter, 4 KiB ROM — no floppy-disk-controller chip; encoding done by custom logic and firmware
Extra SIO commands Download-and-execute ($20), spin test, read address, extended motor timeout, verify sector (documented in the 815 operator's manual)
Power 120 V AC (North America)
DOS 815 Master Diskette CX8201 with DOS 2.0D (DOS 2.0S reconfigured for 256-byte sectors)
Manual Atari 815 Operator's Manual C016377

Why its disks are unique

The 815 stores sector data the "wrong way up" compared with every other double-density drive for the Atari. Other drives store data inverted on disk and the 815 does not, so a disk written by an 815 reads as inverted data on any other drive and vice versa. The firmware also cannot read single density at all (the hardware has no FM mode), so an 815 can neither read nor write ordinary 810 disks. Its status command reports the floppy status byte non-inverted, and its read-address diagnostic is broken in the only known firmware version. There is partial, unfinished provision in the hardware for double-sided and 80-track operation.

Using it today

  • Emulation. Altirra added full emulation of the 815 (read-only), using the one known firmware dump (ROM CRC32s: low ROM A107 32BD3CFD, high ROM C13657E0).
  • Disk interchange. Because of the inverted data, disks are not interchangeable between an 815 and other double-density drives, even though the geometry (40 × 18 × 256 bytes) is the same.
  • Context. Atari's next attempts at more capacity were the 1050's 130K "enhanced density" (1983) and finally true 180K/360K double density in the XF551 (1987).

Credits