Atari 1200XL Field Service: Testing, Symptoms and Tech Tips

Year
1983
Type
Component
Category
Atari service procedure: 1200XL self-test, SALT 2.05, symptom checklist and the 1983 tech tips
Manufacturer
Atari, Inc.
Grey cover of the Atari 1200 XL Home Computer Field Service Manual with a large outlined ATARI logo, dated February 1983, FD 100217 Rev. 01

Overview

Atari's 1200XL Home Computer Field Service Manual (FD100217, Rev. 01) is dated February 1983. Its theory section is summarised in 1200XL internals. This page covers the rest: how a technician tested the machine, the symptom checklist, adjustment and disassembly, and above all the tech tips filed at the back during 1983. They record the 1200XL's teething troubles in Atari's own words. For the machine itself see Atari 1200XL.

Testing a 1200XL

Self-test. Unlike later XLs, the 1200XL enters self-test when you press HELP while the power-on logo is showing, with no cartridge inserted. The memory test draws two long bars for the two 8K OS ROMs and three rows of sixteen 1K blocks for the RAM. While it runs, the 1200XL's two keyboard LEDs blink alternately. The audio-visual and keyboard tests work as on the other XLs, although BREAK neither changes on screen nor beeps. The manual warns against leaving any self-test screen up for long, because it never goes into attract mode.

SALT 2.05. For deeper tests Atari used its SALT 2.05 diagnostic cartridge. Type ? for the menu and pick tests by their red command letter. The manual says only some of SALT's tests apply to the 1200XL. For keyboard, tone and ROM checks, the self-test is used instead. The two most useful are:

  • Colour bars (C): a 15-colour rainbow above a grey reference bar, with one bar below. Turn VR1 until the bars directly above and below the reference are the same golden-rod colour, then leave the test running for at least 60 seconds to catch intermittent faults.
  • Any video (A): a black screen with eight vertical bars, which also checks ANTIC for pattern sensitivity.

Symptom checklist

Symptom Possible causes (board references)
Snowy screen Switch box, AC adaptor, channel switch, RF modulator or cable
Black or grey screen Regulators (7805), 5 V supply, chokes L4–L8, ANTIC, CR8, power plug, switch, crystal Y1
Green or yellow screen U27, U1–U9, U12, U13
Solid blue screen U24, Q2–Q4, Y1, U11
No or bad colour VR1 adjustment, U20, U2, U19, Q3, Y1, RF modulator
No LEDs LED board, +5A supply, U23, Q9, Q10
No grey bars RF modulator, Y1, VR1, Q3
Upside-down characters or players U20, U11, Q3
Some or all keys dead U24, keyboard
Missing tones U24, L11–L12; adjust the audio
Console keys dead U19, U23
ROM test fails U12, U13, U14, U18, U22
RAM test fails U1–U9, U14, U22

Adjustments. The colour pot VR1 and the sound coil can both be reached through holes in the top or bottom cover. The RF modulator needs the shield removed. Alternatively, connect a frequency meter to the RF output, set the channel switch to 3 and tune to 61.25 MHz.

Disassembly. Remove six screws from the base and lift the bottom cover away with the board in it. Six more screws hold the board, and eleven push rivets hold the two halves of the RF shield together around a sheet of fish paper. When reassembling, keep the adjustment holes in the shield clear.

The 1983 tech tips

  • Tech Tip 12: video sync. Some TVs and monitors lost sync: high-contrast screens tore, ghosted or "enlarged". The fix changed resistors R22 (4.3K to 6.2K) and R163 (100 to 150 ohms), replaced R188 with a 1N914 diode, and added an 18K resistor at the unused R145. It was to be done only on affected units.
  • Tech Tip 15 (7 June 1983): audio drift. Sound that faded, vanished or kept needing readjustment came from out-of-spec parts. The cure was to replace the ceramic 820 pF capacitors C96 and C97 in the audio oscillator with polystyrene ones.
  • Tech Tip 18: EPROMs to ROMs. Early 1200XLs shipped with their OS in EPROMs at U12 and U13. If one failed, both had to be replaced with mask ROMs (C060617 at U12, C060616 at U13), and a set of zero-ohm jumpers moved to switch the sockets from 28-pin to 24-pin parts.
  • Tech Tip 18A: the Rev. B OS. This superseded the earlier tip. It replaces Rev. A EPROMs or ROMs with Rev. B ROMs (C060617B and C060616B). Atari says the only difference is a fix to the SYSTEM RESET key, and the swap was to be made only if the OS had failed or the customer complained about RESET. Both chips must always be changed together.
  • Tech Tip 19: no picture on Star Raiders. On some 1200XLs the Star Raiders cartridge gave no picture, because the CPU's reset timing was wrong for it. The fix was a 0.001 µF NPO capacitor soldered between pins 3 and 7 of U16.

Using it today

If you own a 1200XL, check for Tech Tip 12 and 15 modifications before chasing video or sound faults, and identify the OS fitted (see Atari OS ROM for how to read the revision in software). A machine with EPROMs is an early one. The Star Raiders capacitor is a quick fix for a machine that won't show a picture with some cartridges.

Credits