Atari 1064 Memory Module
- Year
- 1984
- Type
- Upgrade
- Category
- RAM expansion (600XL, Parallel Bus Interface)
- Manufacturer
- Atari, Inc.
Overview
The 600XL shipped with only 16 KiB of RAM — enough for cartridges and cassette games, but too little for most disk software and for the XL operating system's trick of putting RAM under the ROMs. Atari's answer was the 1064 Memory Module, a box that plugs into the Parallel Bus Interface (PBI) edge connector on the back of the 600XL. With it fitted, the 600XL has the same 64 KiB memory map as an 800XL (62 KiB usable), including RAM beneath the OS and BASIC ROMs that software can bank in through PORTB.
The module is a straightforward piece of engineering. Rather than replacing the computer's own memory, it leaves the internal 16 KiB enabled and adds the missing 48 KiB, although its DRAM chips physically hold 64 KiB. It takes its power from the PBI itself — the 600XL, unlike the 800XL, supplies +5 V on PBI pins 47 and 48 — so it needs no adapter of its own, and it provides a pass-through connector so further PBI devices can be plugged in behind it.
Specifications
| Item | Detail |
|---|---|
| Host | Atari 600XL (16 KiB) |
| Adds | 48 KiB, for a 64 KiB system total (62 KiB usable); 64 KiB of DRAM on board, of which 48 KiB is used |
| Interface | 50-pin Parallel Bus Interface, with pass-through for additional PBI devices |
| Power | Drawn from the 600XL's PBI (+5 V on pins 47/48) |
| Result | 800XL-equivalent memory map, including RAM under OS and BASIC |
History
Atari introduced a "64K Memory Module" for the 600XL at the June 1983 Summer CES, alongside the 600XL and 800XL themselves, for autumn delivery. It was promoted as the 1064 at the West German launch of the 600XL in August 1983 (due October) and at the UK launch in September 1983, and was formally introduced again at the January 1984 Winter CES. It belongs to the same family of PBI products as the 1090 XL Expansion System, whose specification mentions a RAM card able to run in a "1064 mode" that allows RAM to replace the OS ROM.
The 1064 had plenty of competition. Third-party 600XL upgrades included PBI modules (RC Systems AM1/AM2/AM64, MPP MicroRam 64K, W.E. Electronics packs), internal kits (FirstWare/Mosaic 48K and 64K Expanders, Computer Service Land, Computer Support, York Computer Centre), and a BOT Engineering daughterboard found pre-installed in a small number of 600XLs sold in Canada.
Using it today / Known issues & tips
- XE computers can't use it. The 65XE, 130XE and 800XE dropped the PBI in favour of the physically different Enhanced Cartridge Interface, and the 800XL already has 64 KiB.
- Power. The module runs from the 600XL's own 5 V supply (rated 1.5 A), so use a sound XL power supply — and avoid the failure-prone "Ingot" type of the C061982 brick.
- Software view. To software, a 600XL + 1064 is indistinguishable from a 64K XL; emulators simply configure a 600XL with 64 KiB.
Credits
- Picture: Atari 1064 Memory Module. — Bo Schreurs, Atari POOLDISK 1.0 photos, via the Internet Archive item 'PicturesOfAtari8-BitHardware' (Public domain)
- comp.sys.atari.8bit FAQ (Michael Current) — Michael Current (comp.sys.atari.8bit FAQ)
