SIDE and SIDE2 CompactFlash Cartridges
- Year
- 2011
- Type
- Modern device
- Category
- Cartridge with CompactFlash storage, SpartaDOS X and real-time clock
- Manufacturer
- Sebastian Bartkowicz (Candle'O'Sin), with production by Zaxon (SIDE); Przemysław Krawczyk/Lotharek (SIDE2)
- Tags
- modern, cartridge, compactflash, ide, spartados-x, rtc, side, side2, lotharek, candle
Overview
The SIDE cartridge, designed by Sebastian Bartkowicz (Candle'O'Sin) in 2011, made hard-disk-style mass storage plug-and-play for any XL/XE. Plug it into the cartridge slot and you get three things at once: - a CompactFlash card interface (CF cards are IDE devices underneath) - SpartaDOS X in on-board flash - a real-time clock with battery backup
A switch chooses between two modes. SDX mode boots SpartaDOS X with the CF card available as hard-disk partitions. Loader mode runs a menu that browses a FAT-formatted card and launches games and programs directly. In 2012 Przemysław Krawczyk (Lotharek) released the revised SIDE2, which added CF hot-swapping, a programmable "SIDE button", better banking and an LED.
Specifications
| Item | SIDE (2011) | SIDE2 (2012) |
|---|---|---|
| Storage | CompactFlash slot (8-bit transfer mode) | CompactFlash with card-removal sensing (hot swap) |
| Flash | 512 KB (4 Mbit), programmable in place | 512 KB, with 256 KB free for an external application cartridge |
| Cartridge emulation | Pass-through SpartaDOS X plus a second "top" cartridge, separately banked | Same, with readable banking registers |
| Clock | Maxim DS1305 RTC with battery and 96-byte NVRAM | Same |
| Mode switch | SDX / Loader | SDX / Loader, plus programmable SIDE button |
| Registers | $D5E0-$D5FF |
Same (not fully compatible with SIDE) |
How it works
The flash chip is used to emulate two stacked cartridges: a pass-through SpartaDOS X cartridge and a second cartridge "on top" of it. Each has its own bank register, and a physical switch can disable the SDX half regardless of software. The CF card's eight ATA registers are exposed directly, using only the lower 8 data bits, so the card runs in 8-bit transfer mode. The clock and NVRAM sit on an SPI bus driven through control bits.
Software
- SIDE Loader by Jonathan Halliday (flashjazzcat) is the standard menu firmware for both SIDE and SIDE2. It loads XEX files and mounts ATR disk images from FAT16/FAT32 cards.
- SpartaDOS X drivers for SIDE and SIDE2 (also by Jonathan Halliday) give access to APT-partitioned hard disks on the card, with real-time-clock date stamps.
- The Ultimate 1MB BIOS integrates with SIDE, and the AVGCart and SUBCART can emulate a SIDE2 for software compatibility.
Using one today
- The cartridge drives CF cards in 8-bit mode, so the card must support that mode.
- Set the switch to Loader for "drag-and-drop" game collections on a FAT card. Use SDX mode with partitioned storage for a full hard-disk-style DOS setup.
- Its successor, the SIDE3, uses SD cards instead of CompactFlash.
- Altirra emulates SIDE and SIDE2 (including in save states), which is handy for preparing card images.
Credits
- Picture: Lotharek's SIDE2 cartridge. — Product photo from Lotharek's Lair (maker/vendor) (© Lotharek, used for identification)
- comp.sys.atari.8bit FAQ (Michael Current), section 3.3.4 (SIDE Cartridge, SIDE2 Cartridge) and 3.3.5 (AVGCART SIDE2 emulation) — Michael Current (comp.sys.atari.8bit FAQ)
- Altirra Hardware Reference Manual, section 8.5 SIDE 1 / SIDE 2 — Avery Lee (Altirra)
- Altirra emulator release notes (SIDE/2/3 save states) — Screenshot from Avery Lee's Altirra page, virtualdub.org
