AtariLab
- Year
- 1984
- Type
- Peripheral
- Category
- Science-laboratory interface and sensor modules for schools (1984–85)
- Manufacturer
- Atari, Inc. (Atari Learning Systems); developed by Dickinson College
Overview
AtariLab turned an Atari computer into a laboratory instrument for school science classes. It was developed at Dickinson College in Carlisle, Pennsylvania, under Priscilla W. Laws, head of the college's Physics and Astronomy department, who argued that students learn science by doing experiments rather than reading about them. Atari previewed the series as "ScienceLab" at the June 1983 Consumer Electronics Show and sold it through its education division, Atari Learning Systems.
The Starter Set
The AtariLab Starter Set ($89.95) shipped in spring 1984 and contained:
- the AtariLab Interface, a box that plugs into controller port 2 and is needed for every AtariLab module (but came only with the Starter Set);
- a hand-held electronic temperature sensor on a 30-inch lead;
- an ordinary alcohol "student thermometer" for calibration;
- the Temperature Module program cartridge (16K);
- a 144-page manual with more than 100 experiments on temperature and heat.
With the Temperature Module running, the computer becomes a recording thermometer covering −5 to 45 °C (23–113 °F) over periods from 10 seconds to 24 hours. Readings are plotted live as colourful graphs and can be saved to disk or printed, and the software accepts joystick or keyboard input.
How the interface works
AtariLab makes clever use of the controller port. The interface box has four pairs of phono jacks, labelled for the left and right sides: PADDLE, PTRIG, CONTROL and POWER. The paddle jacks feed the port's two POKEY pot inputs, so any sensor whose resistance behaves like a paddle — such as the temperature probe — can be read; the trigger and control jacks connect to switch-type inputs like the paddle triggers and joystick lines; and the power jacks supply the computer's +5 V. Antic pointed out that "creative students" could build their own sensors for it.
Modules: planned and shipped
AtariLab was meant to grow by one $49.95 module every four to six months. Over 1983–84 Atari announced Light, Timekeeper, Biofeedback, Mechanics, a Crimelab module with a "Lie Detector" program, low-level radiation and robotics modules, a high-range temperature sensor and a disk-based Advanced Temperature Module. Only the Light Module followed, shipped by Atari Corp. in 1985; the others, and the planned AtariLab Curriculum Modules, never appeared. Disk versions for Apple and Commodore computers were also reported to be in production.
In the classroom
Antic's October 1984 report followed a trial at Isaac Newton Junior High School in New York's Spanish Harlem, which received three Starter Sets in April 1984. Teachers found them easy to use and popular, and students invented experiments the developers had never considered — one measured friction by rubbing the sensor across different surfaces. The criticisms were practical: the sensor's short lead put the computer uncomfortably close to liquids, the plastic sensor could be dissolved by solvents such as acetone, the system could only record (not control) experiments, and teachers wanted disk-based, modifiable software and a sensor for higher temperatures. A University of Pennsylvania pharmacologist planned to use an 800XL with the Light Module in place of $1,300 of laboratory equipment.
Using it today
AtariLab hardware turns up occasionally, usually as the Starter Set. It plugs into controller port 2, which every 8-bit Atari has, and the Temperature and Light Modules are cartridges, so no disk drive is needed. Because the interface simply exposes the port's paddle, trigger and +5 V lines on phono sockets, it also makes a convenient breakout for home-made analogue sensors.
Credits
- Picture: The AtariLab Starter Set: interface box, temperature probe, calibration thermometer and Temperature Module cartridge. — Brian Jepson, via Wikimedia Commons (CC BY-SA 2.5)
- Charles Jackson, 'AtariLab: New breakthrough in science learning', Antic vol. 3 no. 6 (October 1984) — Charles Jackson; AtariMagazines.com (Kevin Savetz), 1984
- comp.sys.atari.8bit FAQ (Michael Current) — 11.1 timeline (June 1983 CES preview as ScienceLab; NECC/5; 1983-84 announcements; spring 1984 shipment; Light Module 1985) — Michael Current (comp.sys.atari.8bit FAQ), 1983
