Anchor Automation Signalman and Volksmodem
- Year
- 1983
- Type
- Peripheral
- Category
- Direct-connect modems (300 and 1200 baud)
- Manufacturer
- Anchor Automation, Inc. (Van Nuys, California)
Overview
Anchor Automation of Van Nuys, California made some of the cheapest direct-connect modems of the early 1980s, and several models came with Atari cables. The Best of Antic spotted the Signalman Mk I at "an unbelievable price of $99, including RS-232 connector cable" and predicted it "could be the forerunner of a price revolution". The later Volksmodem line kept prices low. By 1986 Antic's Shoppers Guide listed the Volksmodem 10, a 300-baud modem that plugged straight into the Atari's joystick port 2, at $79.95, and distinguished it from the Hayes-compatible 1200-baud Volksmodem 12, which needed an 850-compatible interface.
Models used with the Atari
| Model | Speed | Connection | Notes |
|---|---|---|---|
| Signalman Mark I | 300 | RS-232 (850) | $99 with cable |
| Signalman Mark II (300-232 09M) | 300, Bell 103 | Atari 850 port 1, cable built in | Auto-dial, 9 V battery or adapter |
| Signalman 300-232 09F / Auto300-232 | 300 | Joystick port | Same units as the MPP-1000 and MPP-1000C |
| Volksmodem VM1 | 300, Bell 103 | C cable (850) or F cable (joystick port 2, 1984) | Powered from the phone line with 9 V battery backup; voice/data and full/half-duplex switches |
| Volksmodem 10 | 300 | Joystick port 2 | $79.95 in 1986 |
| Volksmodem 12 | 1200, Hayes-compatible | 850-compatible interface |
The Signalman Mark II in practice
The Mark II's instruction sheet shows how simple these modems were. It runs on an internal 9 V battery (or an optional adapter) and has no LEDs. Instead it has an audible carrier-detect tone and switches between Originate and Answer mode automatically. You plug the telephone handset into the modem's HANDSET jack, connect the phone base to its TELSET jack, and plug the attached cable into port 1 of the 850. Power the 850 before the computer. To call, dial by voice with the switch on VOICE, then flip it to DATA. The tone stops once the remote carrier is heard. The sheet notes that it doesn't work with Trimline phones, which have the dial in the handset. The DATA/VOICE switch also turns the battery off, so leave it on VOICE when not in use.
Joystick-port versions
The F-cable Volksmodem and the 09F/Auto300 Signalman connect through a joystick port and are driven entirely by software. They use the same driver approach as Microbits' MPP modems, and in fact the same drivers: the MPP-1000C/1000E/300AT software. A program needs that driver. Plain 850 R: software won't see these modems.
Using one today
These are 300-baud phone-line modems, now of interest mainly to collectors. For actual BBS use today, a Hayes-command serial device on an 850, or a networked SIO device, is far more practical. The joystick-port models are a good illustration of how much serial I/O the Atari could do in pure software.
Credits
- Picture: Anchor Automation's Volksmodem 12. — Photo from Gury's Atari 8-bit Forever portal (Volksmodem 12) (Unknown, used for identification)
- Signalman Mark II instruction sheet for use with Atari 850 (Anchor Automation) — Internet Archive
- Best of Antic Volume 1: Modems (Signalman MK-1) — AtariMagazines.com (Kevin Savetz)
- Antic Vol. 5 No. 8 (December 1986), Shoppers Guide: Volksmodem 10 — AtariMagazines.com (Kevin Savetz), 1986
- comp.sys.atari.8bit FAQ (Michael Current), section 5.1.2 (Signalman Mark II, Volksmodem VM1, MPP equivalents) — Michael Current (comp.sys.atari.8bit FAQ)
